Operating manual for E+L tenter guider infeed KRS models with DC 5501/5506 controllers, covering installation, setup and operation.
This operating manual covers E+L tenter guider infeeds KRS 47, KRS 49, KRS 51/KRS 52 and KRS 55/KRS 56, used with digital controller DC 5501/5506 and actuator KR 47../51../52../56.. It describes safety instructions, function and design, transport, assembly, installation, the setup editor, commissioning, operation, optimization, troubleshooting/repair, maintenance and technical data.
The tenter guider positions the infeed rails at the actual position of the web so the web edges are taken up correctly on the chain pins or clips. Sensors mounted on the infeed rails scan the web edges, and the digital controller evaluates deviations and sends correction signals to the actuator.
| Models covered | KRS 47, KRS 49, KRS 51/KRS 52 and KRS 55/KRS 56 |
|---|---|
| Digital controller | DC 5501/5506 |
| Actuator | KR 47../51../52../56.. |
| Adjusting movement | Trapezoidal ball screw on KR 47; rack on KR 51, KR 52 and KR 56 |
| Temperature protection | Temperature-dependent reduction of power |
It applies to KRS 47, KRS 49, KRS 51/KRS 52 and KRS 55/KRS 56.
It sets the infeed rails to the actual position of the web so the web edges are taken up correctly.
On units with a KR 47 actuator it uses a trapezoidal ball screw; with KR 51, KR 52 and KR 56 actuators it uses a rack.
It monitors pinning or clipping at the tenter infeed.