Instructions for the Dremel 568 Grout Removal Attachment, covering compatible Dremel models, bits, installation, speeds and cutting depth.
The Dremel 568 Grout Removal Attachment is a preassembled accessory for removing old grout or grout around broken tiles. The document lists recommended Dremel tool models, describes the included #569 1/16-inch bit and optional #570 1/8-inch bit, and gives installation steps for mounting the attachment on a rotary tool.
It also covers recommended operating speeds of 15,000 to 20,000 RPM, the 30-degree attachment angle, and the two guides that help center the bit between tiles. Cutting-depth adjustment is explained for cleaning grout and for removing grout to replace a broken tile, with limits on depth and increments.
| Attachment model | 568 |
|---|---|
| Recommended speed | 15,000 to 20,000 RPM |
| Attachment angle | 30 degrees |
| Included bit | #569, 1/16 in. diameter |
| Optional bit | #570, 1/8 in. diameter, sold separately |
| Collet size | 1/8 in. collet, #480 |
| Depth adjustment increment | 1/8 in. (3.2 mm) |
| Maximum grout removal depth when cleaning | 3/8 in. below tile face |
It is recommended for Dremel models 100, 200, 275, 285, 300, 395, 398, 400, 800, 3000, 4000, 8100, 8200, 8220 and 4200.
Recommended speeds are between 15,000 and 20,000 RPM; exceeding them can damage the bit.
The document recommends the #570 1/8-inch bit for tile spacing greater than 1/8 inch.
Do not remove grout more than 3/8 inch below the face surface of the tile, and regrout to tile level afterward.