User manual for the DIY K191 3-channel RGB LED controller kit: connections, serial commands, Windows software, sequences and assembly.
The DIY K191 is a kit that works as a standalone LED control module with 3 high current channels for common anode RGB LED strips, single LEDs and 12V incandescent bulbs. The board contains a microcontroller, a 5V voltage regulator and high current MOSFETs, and it stores 6 preprogrammed light sequences plus one custom user-editable sequence, with the last selected sequence kept in memory. Effects are switched with a push button, and the module can be addressed so that several modules are controlled independently.
The manual covers the wiring options, the preprogrammed sequences, the serial command set (0xFE prefix with device address, command and parameters) used over a serial TTL or RS232 link, and the Windows software that sets intensities and downloads the custom sequence. It ends with the parts list, PCB and schematic section and step-by-step kit assembly instructions, including the order in which components should be soldered.
| Operating Voltage | 12 VDC (nominal) |
|---|---|
| Channel Current | 5 A max per channel, 12 A max for all 3 channels |
| LED PWM frequency | 480 Hz |
| LED intensity control | 250 intensity levels per channel |
| Communication Interface | Serial RS232 and serial TTL, 9600 baud, 8 data bits, 1 stop bit, no parity, no handshaking |
| Dimensions | 2.2” x 1.55” x 0.5” (56 x 39 x 12 mm) |
It has 3 high current channels that can be controlled independently.
The module operates from 12 VDC nominal.
There are 6 preprogrammed light sequences, and a seventh slot holds the custom user-editable sequence.
The default module address is 0x4C, and address 0x00 is a common address for all modules.