Digi XBee Industrial Gateway Telit Modem Firmware Update Guide

About this manual

This guide provides instructions on how to update the cellular modem firmware of the Digi XBee Industrial Gateway (XGI-2PCZ7-EL1-W0) to comply with Verizon network changes occurring on March 30th, 2019. It applies to the gateway containing the nTelit LE910-NA1 modem.

What's inside

• Verizon network changes
• Determine if an update is needed
• Find the modem revision
• Update the Modem Firmware
• Update over the air (FOTA)
• Update over an Ethernet connection
• Verify the update was successful
• Troubleshooting the update

Frequently asked questions

What firmware revision is required for a DigiXBee Industrial Gateway with a Verizon SIM?

The required modem firmware revision is 20.00.015.0.

What is the minimum gateway firmware version needed to update the modem?

The gateway must run firmware version 3.2.29.8 or later.

What command is used to check the modem revision via the command line?

You must perform the command wancminfo after SSHing into the gateway.