Reference manual for the DID1 ECU engine control unit covering wiring, pin-outs, software configuration, cruise control, OBD2 communications and error codes.
The DID1 is an engine control unit for common rail diesel engines with up to 8 cylinders equipped with solenoid injectors. It can also drive unit injectors and some spill valve controlled injection pumps.
The manual covers connector pin-outs, wiring diagrams and wiring guidelines, along with software configuration and firmware upgrades. It also documents extended features such as cruise control and OBD2 communications, error codes, and reference wiring diagrams for several Mercedes-Benz, Toyota, BMW and Ssangyong applications.
| Injector outputs | 8 |
|---|---|
| Injector boost voltage | Software configurable up to 100 V |
| Injector peak current | Software configurable up to 32 A |
| Injector high current phase | Up to 30 A |
| Injector hold current | Up to 21 A |
| Low-side switch outputs | 15 configurable, 7 PWM capable |
| High-side switch outputs | 1 configurable |
| Analog inputs | 14, 0-5 V |
| General purpose digital inputs | 8 |
| K-type thermocouple input range | 0 to 1350 °C |
| On-board data logging memory | 8 GB |
| CAN interfaces | 2 CAN 2.0B |
| LIN bus interface | 1 |
| Analog output | 1, 0-5 V |
| PC communication | USB 2.0 |
The DID1 is an engine control unit for common rail diesel engines with up to 8 cylinders equipped with solenoid injectors. It can also drive unit injectors and some spill valve controlled injection pumps.
It has 8 injector outputs. Controllers ordered for plug-and-play operation with Mercedes Benz OM61x engines have only 6 injector outputs.
The injector boost voltage is software configurable up to 100 V.
The ECU has 8 GB of on-board data logging memory.