DDF Series Closed Electric Furnace User Manual

Chinese user manual for the DDF series closed electric furnace covering its uses, main features, technical specifications and use and maintenance steps.


DDF Series Closed Electric Furnace User Manual - cover page
Category
Ovens
Document type
User Manual
Language
Chinese
Pages
1
File format
PDF
File size
108 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
27072D48BE081C26F98F80A9D8DC6992

About this manual

This is the Chinese user manual for the DDF series closed electric furnace (DDF-1KW, DDF-1.5KW and DDF-2KW). The text states that the unit is used for baking and drying samples and for other temperature tests, and lists the biological, genetics, medical and health, environmental protection, biochemical laboratory, analysis room and educational research settings where it is used.

The manual gives the main features of the furnace, a technical specification table covering heating power, working area, outer dimensions and power supply, and short use and maintenance instructions describing how to prepare the work surface, place sample vessels, switch on the unit and adjust the potentiometer, and shut it down after work. This manual is written in Chinese.

What's inside

  • Product Introduction
  • Main Features
  • Technical Specifications
  • Use and Maintenance

Specifications

ModelsDDF-1KW, DDF-1.5KW, DDF-2KW
Heating power1000W / 1500W / 2×1000KW (as printed)
Working areaФ15.5cm / Ф18.5cm / 2×Ф15.5cm
Outer dimensions26×22×70cm / 29×26×70cm / 46×26×70cm
Power supplyAC 220V±10%, 50Hz

Frequently asked questions

What power supply does the DDF series closed electric furnace require?

The manual states an AC 220V±10%, 50Hz power supply.

How should the work surface be prepared before use?

Wipe the work surface clean; no water drops, dirt, scale or other foreign matter may remain on it.

How is the furnace switched on and adjusted?

Connect the power, then turn the voltage-regulating potentiometer from 0 to 1 so that the indicator lamp lights, and continue to 5 for increasing power up to maximum.

What should be done when work is finished?

Turn the potentiometer back to 0, cut off the power, and after the work surface has cooled treat it as described in step 1.

Download PDF (108 KB)

Also Manuals