Dayton Audio DATS V2 Speaker Test System Quick Start Guide

Dayton Audio DATS V2 speaker test system quick start guide covering software setup, calibration, speaker measurement, and troubleshooting.


Dayton Audio DATS V2 Speaker Test System Quick Start Guide - cover page
Brand
DaytonAudio
Category
Test Set
Document type
Quick Start Guide
Language
English
Pages
4
File format
PDF
File size
638 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
2EFCE29069A58A4CA5F294044FB015A0

About this manual

The Dayton Audio DATS V2 is a loudspeaker test system that runs under Windows Vista, 7, 8, and 10. This quick start guide gives step-by-step instructions for installing the software, connecting the hardware unit to a USB port, launching the application, and calibrating the test leads and system.

It then explains how to test a speaker, measure free-air parameters and Vas using one of four methods, save or export data, quit the application, and verify settings if troubleshooting is needed. It includes a safety note that the test leads must never be connected to a speaker connected to other equipment or ground.

What's inside

  • Install the DATS V2 software
  • Connect the DATS V2 hardware unit
  • Launch the DATS V2 application software
  • Calibrate the test leads
  • Calibrate at 1 k ohms
  • Test a speaker
  • Measure Free Air Parameters
  • Measure Vas
  • DATS V2 Troubleshooting
  • Future sessions with DATS V2

Specifications

Operating systemWindows Vista, 7, 8, 10
ConnectionUSB port
Test lead resistanceLess than 1 ohm
Calibration resistor tolerance±0.1 %
Expected 1 kohm calibration reading995 to 1005 ohms
Input format2-channel at 44.1 kHz
Project file format.tzz
Export formats.txt or .zma

Frequently asked questions

What operating systems does the DATS V2 run under?

It runs under Windows Vista, 7, 8, and 10.

Can I connect the DATS V2 test leads to a speaker that is connected to an amplifier?

No. The guide says never to connect the test leads to a speaker connected to any other equipment or to an equipment ground.

What should the test lead resistance be after calibration?

It should be less than 1 ohm.

What input settings does the DATS V2 require?

It requires 2-channel input at 44.1 kHz; it will not operate correctly with 1 channel or other sampling frequencies.

Download PDF (638 KB)

More DaytonAudio Manuals


View all DaytonAudio manuals →