The CME 2 User Guide provides installation, configuration, and operation instructions for Copley Controls' CME 2 motion‑control software and hardware.
This manual introduces the CME 2 software environment, detailing system requirements, supported communication interfaces (RS‑232, CANopen, EtherCAT), and step‑by‑step installation procedures for Windows XP, 7, and 8. It also covers driver setup, basic configuration, motor and feedback parameter tuning, digital I/O mapping, command input, and network configuration.
Further sections describe error handling, motor homing methods, control loop tuning (current, velocity, position), stepper debugging, virtual driver usage, gain planning, regeneration resistance configuration, and the ASCII command interface. Safety warnings and recommended hardware (e.g., B&B USB‑to‑Serial adapter) are included throughout. This manual is written in Chinese.
| Minimum CPU | 1 GHz |
|---|---|
| Minimum RAM | 1 GB |
| Supported Operating Systems | Windows XP, Windows 7, Windows 8 |
| Serial Communication Interface | Standard RS‑232 or USB‑to‑RS‑232 adapter |
| CAN Communication Cards | Copley Controls CAN‑PCI‑02, Kvaser, IXXAT |
The software requires at least a 1 GHz CPU and 1 GB of RAM.
CME 2 runs on Windows XP, Windows 7, and Windows 8.
It uses a standard RS‑232 serial port or a USB‑to‑RS‑232 adapter.
Compatible cards include the Copley Controls CAN‑PCI‑02, Kvaser, and IXXAT devices.