CompuLab FACE Module Design Guide

This guide provides interface specifications and design requirements for custom FACE modules for CompuLab industrial PCs, covering PCIe, SATA, USB, and…


CompuLab FACE Module Design Guide - cover page
Brand
CompuLab
Category
Other Electronics
Document type
Other
Language
English
Pages
17
File format
PDF
File size
277 KB
Published
31 October, 2026
Updated
31 October, 2026
MD5 checksum
1A0CECBDABD38E3D7693731A677ACB12

About this manual

This document outlines the interface specifications and design requirements for custom Function And Connectivity Extension (FACE) modules used with CompuLab industrial PCs. FACE modules consist of an internal extension board connected to the PC motherboard via board-to-board connectors featuring standard PC interfaces such as PCIe, USB2, SATA, and SMBus, along with a simple sheet-metal panel.

The guide details specific signal definitions, pin assignments, and electrical design recommendations for various interfaces including PCIe, SATA, USB, SMBus, Digital Audio, LPC, and GPIOs. It also provides mechanical design considerations and general electrical guidelines, such as trace impedance targets and power rail implementation strategies, to ensure proper system signal quality and integrity.

What's inside

  • Introduction
  • FACE Module Concept
  • PCIe Interface
  • SATA Interface
  • USB Interface
  • SMBus Interface
  • Digital Audio Interface
  • LPC Interface
  • GPIOs
  • Power Signals

Specifications

Target impedance for PCIe differential pairs85 Ω ± 15%
Target impedance for SATA differential pairs90 Ω ± 10%
Trace impedance for single-ended signals50-55 Ω ± 15%
Trace spacing for PCIe pairs≥ 4:1
Trace spacing for SATA pairs≥ 5:1
AC coupling capacitor for PCIe receive signals100nF

Frequently asked questions

What interfaces are supported by the FACE module?

The FACE module supports standard PC interfaces such as PCIe, USB2, SATA, SMBus, digital audio, LPC, GPIOs, and power rails.

Where are the AC coupling capacitors for SATA signals located?

AC coupling capacitors for SATA signals are located on the fit-PC3 motherboard, not on the FACE module PCB.

What is the recommended trace impedance for single-ended signals?

The recommended trace impedance for single-ended signals is 50-55 Ω ± 15%.

Download PDF (277 KB)

More CompuLab Manuals


View all CompuLab manuals →