Installation and operation guide for the CEDES Max-32T safety light curtain, covering safety notes, wiring, setup, and troubleshooting.
This manual provides detailed instructions for installing and operating the CEDES Max-32T photoelectric safety light curtain. It includes safety precautions, wiring diagrams, power supply requirements, and adjustment procedures to ensure reliable performance in industrial door applications.
The document also covers testing procedures, troubleshooting tips, and technical specifications such as beam count, detection range, response times, and environmental ratings. Users are guided through proper mounting, cable selection, and configuration of the control box and relay outputs. This manual is written in Chinese.
| Maximum detection range | 12 m |
|---|---|
| Input voltage range | 17 – 240 VAC/DC |
| Maximum response time | 180 ms (typical 90 ms) |
| Protection rating (light curtain) | IP65 or IP67 |
The Max-32T can operate with an input voltage from 17 V to 240 V AC or DC without any adjustment.
Use the potentiometer on the control box: set it to the maximum position, rotate clockwise to the midpoint between maximum and minimum, then fine‑tune until the yellow LED lights up.
The green LED shows that the unit is powered, while the yellow LED indicates that the test input is high and the relay output is in the OK state.
The sensor’s maximum response time is 180 ms, with a typical response of 90 ms.