Installation guide for BD Sensors LMK and LMP probes with wiring, mounting, and disassembly instructions.
This guide provides step-by-step instructions for installing BD Sensors LMK and LMP probes. It covers electrical connections, mounting with flanges or clamps, and disassembly/reassembly procedures. Safety warnings emphasize that only qualified personnel should perform installation. The guide also includes pin configurations for different cable types and connector series.
The document lists specific models including LMK 306, LMK 307, LMP 305, and others, and includes wiring diagrams for 2-wire, 3-wire, and HART systems. It advises using shielded cables and provides torque values for flange mounting. For high-viscosity media, it details how to remove protective caps without damaging the sensor membrane. This manual is written in German.
| Mounting Torque | Approx. 25 Nm |
|---|---|
| Connector Series | Binder Serie 723 (5-pin) and (7-pin) |
Flange probes should be tightened with an open-end wrench to approximately 25 Nm.
Flange version has to be tightened by an open-end wrench. (approx. 25 Nm).
Use a small tool such as a screwdriver to slide through two opposite drill holes and lever the cap off.
LMK 306, LMK 307, LMK 307T, LMK 309, LMK 358, LMK 358H, LMK 382, LMK 382H, LMK 80 6, LMK 80 7, LMK 808, LMK 809, LMK 858, LMP 305, LMP 307, LMP 307i, LMP 307T, LMP 308, LMP 308i, LMP 808.