Quickstart guide for the Arcam irDAC digital-to-analogue converter, covering connections, power adaptor setup, input selection and remote control.
The Arcam irDAC is a digital-to-analogue converter. This Connections and Quickstart Guide provides guidance for connecting and using it, including power adaptor setup and rear-panel connectors for coaxial and optical digital inputs, USB, Apple/USB, audio outputs and digital output.
Input selection is made with the top button, which cycles through the inputs; the corresponding front-panel LED is green when a valid signal is present and red when no signal is detected. The CR107 remote control can adjust volume and mute on an Arcam amplifier and operate transport functions for a connected Apple device or USB HID-compatible media software.
| Power input | 12 V DC, 1.5 A |
|---|---|
| Audio outputs | Left and right analog outputs |
| Coaxial digital inputs | Inputs 1 and 2 |
| USB class switch | Class I or II |
| Output level | Line level (maximum volume) at all times |
Ensure the rear power switch is set to on, then press the top button to cycle between the different inputs.
The corresponding LED lights green when a valid signal is present and red when no signal is detected.
It uses a 12 V DC, 1.5 A power adaptor.
The volume and mute buttons control any Arcam amplifier; the irDAC output stays at line level (maximum volume) at all times.