User manual for the Antari DNG-200 low fog generator: installation, D-20 LCD controller settings, operation, safety and maintenance notes.
This is the user manual for the Antari DNG-200 Low Fog Generator, a low fog special effect machine that integrates the fog generator into the unit to save stage space and that does not use carbon dioxide. The manual covers safety cautions, unpacking and inspection, installation procedures, operation, the D-20 LCD screen controller and other important notes.
The installation section describes moving and fixing the machine, connecting the two Powercon power cords (upper for the fog generator, bottom for the compressor), attaching the black fog conducting hose and filling the tank with Antari FLR Light Fog Fluid. The operation and controller sections explain warm-up, DMX 512 use, and how to set fog output interval (10-300 seconds), duration (10-100 seconds), volume (four settings) and the DMX 512 address through the D-20 controller's function buttons.
| Heater average temperature | 220°C |
|---|---|
| Ideal operating temperature | 10 - 30 degrees Celsius |
| Fog output interval setting range | 10 to 300 seconds |
| Fog output duration setting range | 10 to 100 seconds |
| Volume setting - High | About 60% output volume |
| Volume setting - Medium | About 52% output volume |
| Volume setting - Low | About 35% output volume |
| Fog conducting hose length | 3 meters |
| Water drain tube | 6 mm PU tube, 3 meters |
| DMX connectors | 3-pin and 5-pin DMX connectors at the back panel |
| D-20 controller cable length | 2 meters |
Only Antari FLR Light Fog Fluid should be filled into the tank; no other fluid should be used.
No. According to the manual the machine does not use carbon dioxide, and it is a low fog special effect machine that does not use dry ice.
After warm-up, when the controller screen shows "Ready To Fog", press the Manual button for a few seconds to drain out the air in the liquid pipe; repeat this if the machine is not frequently used.
The ideal operating temperature is between 10 and 30 degrees Celsius, and the device is for indoor use only.
Press the Function button once for "Interval Set" and twice for "Duration Set", then use the Up/Down keys; the interval range is 10-300 seconds and the duration range is 10-100 seconds.