User manual for the Airnergy+ Basis Plus device covering intended use, setup, operation, service functions, maintenance, and technical data.
The Airnergy+ Basis Plus User Manual covers important information, directions for use, starting up the device, operating the control panel, service functions, care of the device, Service-Check 2000, technical data, accessories, and ISO certificates. It lists safety standards including IEC 60601-1 series and states that the device is operated with the supplied FW7362M/12 mains adaptor at 12 V DC.
The manual describes inhalation of physical conditioned ambient air through nasal cannulas to improve the regulation ability of the autonomic nervous system. It includes a recommended application time of 40 minutes at 100% intensity, selectable intensity levels of 50%, 75%, and 100%, air filter replacement every 50 hours, and automatic shutdown after 15 minutes without operation.
| Mains adaptor | FW7362M/12 from FRIWO Gerätebau GmbH |
|---|---|
| Device input | 12 V DC |
| Maximum ambient temperature | 40°C |
| Maximum atmospheric humidity | 90 % |
| Air filter replacement interval | Every 50 hours |
| Intensity levels | 50%, 75%, and 100% |
| Recommended application time | 40 minutes at 100% intensity |
| Automatic shut down | After 15 minutes without operation |
| Warranty | Two years from the date of invoice |
| Water fill for glass bottle | Approx. 250 ml, max. half-full |
The manual states it is for inhalation of physical conditioned ambient air through nasal cannulas to improve the regulation ability of the autonomic nervous system.
It should be replaced every 50 hours; at 50 hours the display shows a “Change filter” message.
In Operational Mode 1, the INTENSITY button selects 50%, 75%, or 100% intensity.
A brief acoustic signal sounds; after a short run-on the device is operational again and the application can be resumed with START.