Service manual for Aero-Motive 1051X and 5XXXXL cable reels: mounting, wiring, spring tension, collector ring and working cable replacement, parts list.
This service manual (SM3180-05B) from Aero-Motive Company, a Woodhead Industries subsidiary, covers the Cable Reel Series 1051X and 5XXXXL. It opens with safety warnings and cautions, then gives mounting requirements for the fixed base, notes on the optional pivot base, input power wiring in the junction box, and instructions for internal grounding of standard and CSA-built reels.
The operating and service sections describe the ratchet lock, adjustment of the cable guide arm to four fixed positions, and pretensioning the spring with two pretension turns before the working cable end is connected. Service procedures cover replacement of the sealed spring and spring pocket assembly, the collector ring and brush assemblies, and the working cable, followed by a replacement parts list with reference numbers and part numbers.
| Main shaft mounting position | Must be horizontal |
|---|---|
| Guide arm positions | Four fixed positions |
| Pretension turns | Two pretension turns |
| Input power opening | 1" x 11 1/2" N.P.S.C. pipe thread |
| Cable connector range (H80130001) | Cable OD .375 - .437 inch |
| Ratchet lock operation | Works in any position |
Wrap all cable onto the reel and engage the ratchet, pull cable out far enough for one full wrap, wrap it back to set one turn, repeat to place two pretension turns, then pull the cable out completely to check that enough spring revolutions remain. Connect the cable end only after tension is set.
No. The spring must never be removed from its sealed pocket assembly; if the reel will not develop tension, replace the whole spring pocket assembly.
No. Standard reels are not grounded internally except for reels built to CSA standards; internal grounding requires jumper wires from the brush assembly and terminal block to the grounding screw.
The reel can be mounted base up, base down, or wall mounted, with the main shaft horizontal and the drum center line in line with the cable run.