3B Scientific 3B LASER NEEDLE Low-Level Laser Therapy System User Manual

Operating instructions for the 3B Scientific 3B LASER NEEDLE low-level laser therapy system, covering installation, use, maintenance and safety.


3B Scientific 3B LASER NEEDLE Low-Level Laser Therapy System User Manual - cover page
Brand
3B SCIENTIFIC
Category
Professional medical equipment
Document type
User Manual
Language
German
Pages
45
File format
PDF
File size
1.6 MB
Published
10 November, 2026
Updated
10 November, 2026
MD5 checksum
10F84FDEC121ACF93ECCF45AF3148236

About this manual

The 3B LASER NEEDLE by 3B Scientific is a low-energy laser system (low-level laser) for treating pain, trigger and acupuncture points. It is intended exclusively for use in medical practices and clinics and may only be operated under the constant supervision of medical professionals. The manual is printed in six languages (German, English, French, Italian, Spanish and Portuguese).

The system consists of a Laser Unit, a Control Touch Pad with docking station, a device arm, a table clamp or wall mount, twelve numbered fiber optic cables (LWL), rechargeable batteries and power supply units. The Control Touch Pad and the Laser Unit communicate by radio, and the manual covers installation, intended use, contraindications, operation, application, maintenance, safety information, accessories, status and fault messages, and technical data. This manual is written in German.

What's inside

  • Installation
  • Use
  • Contraindications
  • Operation
  • Usage
  • Maintenance and care
  • Safety information
  • Accessories / Label and warning signs
  • Status, Warning and Fault Messages
  • Technical Data

Specifications

Factory preset values on first switch-on12 x 50 mW, CW, 20 minutes
Power supply100 V - 230 VAC
Minimum bending radius of fiber optic cables1.5 cm
Radio link distanceless than 10 m
Number of fiber optic cables12

Frequently asked questions

What are the factory preset values when the device is first switched on?

12 x 50 mW, CW mode and 20 minutes are preprogrammed; on later switch-ons the last setting is stored.

What is the minimum bending radius for the fiber optic cables?

The minimum bending radius is 1.5 cm; falling below it can damage the fiber optic cable.

How far apart can the Control Touch Pad and the Laser Unit be?

The distance between the two devices must be less than 10 m, in the same room with free line of sight.

Which power supplies may be used?

Only the supplied power supply units may be used, connected to 100 V - 230 VAC.

Download PDF (1.6 MB)

More 3B SCIENTIFIC Manuals


View all 3B SCIENTIFIC manuals →