This document describes the features and characteristics of Siemens AG's CPU 315-2 PN/DP, 317-2 PN/DP, and 319-3 PN/DP products, as well as how to configure the PROFINET interface and ET 200S devices. It also provides an introduction to SIMATIC PROFINET IO and safety tips.
This manual provides step‑by‑step instructions for setting up the PROFINET interface on Siemens SIMATIC CPU 315‑2 PN/DP, 317‑2 PN/DP and 319‑3 PN/DP. It covers safety notices, required tools, hardware wiring, IP address assignment, and configuration in STEP 7.
The guide also includes a learning unit with detailed procedures for installing assembly rails, connecting power, debugging hardware, and downloading the hardware configuration to the CPU. Additional references to related Siemens documentation and online support are provided. This manual is written in Chinese.
| Required assembly rail part number | 6ES7 390-1AE80-0AA0 |
|---|---|
| Required power module part number | 6ES7 307-1EA00-0AA0 |
| Required programming device | PG or PC with Ethernet, 100 Mbps full‑duplex, STEP 7 software |
A warning triangle marks personal‑safety hazards, while symbols without the triangle indicate only property‑damage risks.
The STEP 7 programming software (version 5.3, SP1) is required for hardware configuration.
Only qualified personnel may install and operate the equipment, and the device must be used with Siemens‑approved components.