IBM Security Network IPS and SiteProtector FIPS Implementation Guide SV610000/SV620000/SV630000

This document describes the FIPS implementation guide for IBM Security Network Intrusion Prevention System and IBM Security SiteProtector System.


IBM Security Network IPS and SiteProtector FIPS Implementation Guide SV610000/SV620000/SV630000 - cover page
Brand
IBM
Category
Security Software
Document type
Installation Guide
Language
English
Pages
35
File format
PDF
File size
292 KB
Published
30 November, 2023
Updated
30 November, 2023
MD5 checksum
7C324FE55EEAB7632205946B75C81D24

About this manual

This IBM Security FIPS Implementation Guide explains how to put IBM Security Network Intrusion Prevention System (IPS) appliances and the IBM Security SiteProtector System into FIPS mode. It lists the browser and Java settings needed for FIPS-supported ciphering, the considerations before enabling FIPS mode, and how to restore an appliance to factory defaults before setup.

The guide also covers the Network IPS FIPS error state, including symptoms, confirming an error state, troubleshooting with the syslog, and backup, restore and recovery options using the FIPS-140 Information option. A final chapter describes the SiteProtector FIPS Service and how to configure it for a FIPS-approved mode of operation. The edition applies to Version 2.9 of the IBM Security SiteProtector System.

What's inside

  • Configuring web browsers and Java for FIPS-supported ciphering
  • Implementing FIPS on Network IPS appliances
  • FIPS considerations for Network IPS appliances
  • Restoring the Network IPS appliance to factory defaults
  • Enabling FIPS mode options
  • Network IPS and the FIPS error state
  • Backup and restore options
  • Recovering from a FIPS error state by using the FIPS-140 Information option
  • SiteProtector FIPS Service
  • Safety, environmental, and electronic emissions notices

Specifications

Applies toVersion 2.9 of the IBM Security SiteProtector System
Appliance model numbersSV610000, SV620000, SV630000
Required browser protocol optionUse TLS 1.0
Required Java optionUse TLS 1.0

Frequently asked questions

When must FIPS mode be enabled on a Network IPS appliance?

It must be enabled during initial setup, on a new installation or on an installation restored to factory default settings.

Can FIPS mode be disabled through the IPS Local Management Interface?

No. You must reimage the appliance and perform the initial setup without enabling FIPS mode.

Why can I not access the LMI after enabling FIPS ciphering?

You must configure Java and your browser for FIPS-supported ciphering first.

Can Radius authentication be used in FIPS mode?

No, because the Radius protocol uses MD5 hashes, which are not FIPS-compliant.

Download PDF (292 KB)

More IBM Manuals


View all IBM manuals →