Dell Latitude 7200 2-in-1 Service Manual Regulatory Model: T04J Regulatory Type: T04J001
This service manual for the Dell Latitude 7200 2-in-1 (Regulatory Model T04J, Regulatory Type T04J001) starts with safety instructions and the steps for shutting down the computer in Windows 10, working before and after opening the computer, and disassembly and reassembly procedures. The procedures cover the display unit, SD memory card and SIM card tray, solid state drive, WLAN card, battery, cooling unit, speakers, front and rear camera, smart card cage, docking board, power button board, system board and antenna.
Later sections cover Windows drivers, system setup (entering BIOS without a keyboard, system configuration and video options, security and secure boot, Intel Software Guard Extensions, performance, power management, POST behavior, virtualization support, wireless, maintenance and system log), updating and flashing the BIOS from a USB flash drive, system and setup passwords, and troubleshooting with ePSA diagnostics, the diagnostic LED code table, recovery media options, a WiFi power cycle and flea power release, plus contacting Dell. The document is Dell revision A01 dated 2019 - 05.
| Regulatory Model | T04J |
|---|---|
| Regulatory Type | T04J001 |
| Display cable bracket screws | Two M2.5 X 3 screws |
| Display back assembly captive screws | Six |
| Kickstand opening angle | 145 degrees |
| SIM card slot | Available only on tablets shipping with WWAN module |
| Power button hold time for forced shutdown | About 6 seconds |
Open the kickstand to 145 degrees and loosen the six captive screws securing the display back assembly, then pry the display panel edges with a plastic scribe starting near the docking port. Slide the power switch on the system board to OFF and remove the two M2.5 X 3 screws and the display cable bracket.
The 2,3 light pattern means no memory or RAM (Random-Access Memory) is detected.
Download the BIOS setup program file, create a bootable USB drive and copy the file to it, then boot the computer from the USB drive using F12 and the One Time Boot Menu. Type the BIOS file name, press Enter, and follow the instructions on the BIOS Update Utility screen.
Click or tap the Start button, then click or tap Shut down. If the computer and connected devices do not turn off automatically, press and hold the power button for about 6 seconds.