The Dell™ Networking™ X1000 and X4000 Series Switches Getting Started Guide provides basic information to install and start running the following Dell Networking X-series switches: X1008/X1008P, X1018/X1018P, X1026/X1026P, X1052/X1052P and X4012.
This guide covers installation and initial configuration of Dell Networking X1000 and X4000 series switches, including rack, flat-surface, and wall mounting, management modes, and network connection.
It also describes web-based initial configuration, CLI access, console connection settings, reboot and reset procedures, and Power over Ethernet resources for supported models.
| Regulatory models | X1008, X1008P, X1018, X1026, X4012, X1018P, X1026P, X1052, X1052P |
|---|---|
| Power supply (X1008) | External, 24W |
| Power supply (X1008P) | External, 150W |
| Power supply (X1018) | Internal, 40W |
| Power supply (X1026) | Internal, 40W |
| Power supply (X4012) | Internal, 100W |
| Power supply (X1018P) | Internal, 280W |
| Power supply (X1026P) | Internal, 450W |
| Power supply (X1052) | Internal, 100W |
| Power supply (X1052P) | Internal, 525W |
| PoE power (X1008) | 123 W on ports 1-8 |
| PoE power (X1018P) | 246 W on ports 1-16 |
| PoE power (X1026P) | 369 W on ports 1-24* |
| PoE power (X1052P) | 369 W on ports 1-24* |
| Default switch IP address | 192.168.2.1 |
| Default login | username admin, password admin |
| Console data rate | 9600 baud |
| Console data format | 8 data bits, 1 stop bit, no parity |
| Console flow control | none |
| Console emulation | VT100 |
Press the Mode button for at least seven seconds; the MGMT LED illuminates when Managed Mode is active.
Connect using IP address 192.168.2.1 with username admin and password admin.
Press the Reset button through the pinhole on the switch for more than seven seconds.
Use 9600 baud, 8 data bits, 1 stop bit, no parity, no flow control, and VT100 emulation.