Dell OpenManage Plug-in 1.0 for Nagios Core. This guide provides information about software requirements, system requirements, and procedures to install and uninstall Dell OpenManage Plug-in 1.0.
The Dell OpenManage Plug-in 1.0 for Nagios Core installation guide explains software and system requirements and the steps to install and uninstall the plug-in. The plug-in uses iDRAC with Lifecycle Controller and an agent-free method to monitor 12th generation and later Dell PowerEdge servers. It supports Nagios Core 3.5.0 and later and provides device discovery over SNMP or WS-MAN, device information, overall and component health monitoring, SNMP trap monitoring, and iDRAC console launch.
The guide lists general prerequisites including Perl 5.8.8 or later, Net-IP 1.26 or later, optional Socket6 0.23 or later, and optional SNMPTT. Management systems can run RHEL 7 or 6.5 and SLES 11 or 10; managed systems are iDRAC 8 with LC firmware 2.05.05.05 or 2.04.02.01 and iDRAC 7 with LC firmware 1.66.65 or 1.57.57. Installation uses the Dell_OpenManage_Plugin_v1.0_Nagios_Core_A00.tar.gz package and install.sh; uninstallation uses uninstall.sh, followed by restarting the Nagios Core and, if installed, SNMPTT services. This manual is written in Chinese.
| Supported Nagios Core version | Nagios Core 3.5.0 and later |
|---|---|
| Perl version | 5.8.8 or later |
| Net-IP Perl module | 1.26 or later |
| Socket6 Perl module | 0.23 or later, optional for IPv6 managed systems |
| Net-SNMP Perl module | 6.0.1 or later |
| Management system operating systems | RHEL 7 and RHEL 6.5, SLES 11 and SLES 10 (32-bit and 64-bit) |
| Managed system iDRAC 8 firmware | LC firmware 2.05.05.05 and 2.04.02.01 |
| Managed system iDRAC 7 firmware | LC firmware 1.66.65 and 1.57.57 |
| Supported servers | 12th generation and later Dell PowerEdge servers |
The guide lists Nagios Core 3.5.0 or later, Perl 5.8.8 or later, and Net-IP Perl module 1.26 or later. It also lists optional Socket6 0.23 or later for IPv6 monitoring and optional SNMPTT for receiving SNMP alerts.
Device discovery can use either SNMP or WS-MAN, depending on monitoring needs.
The guide lists iDRAC 8 with LC firmware 2.05.05.05 and 2.04.02.01, and iDRAC 7 with LC firmware 1.66.65 and 1.57.57.
Navigate to the