The Dell Edge Gateway 5000 Series Service Manual provides information on how to disassemble and reassemble the internal components of the computer.
This Dell Edge Gateway 5000/5100 service manual provides safety, preparation, and step-by-step procedures for removing and replacing components such as the top cover, solid-state drive, wireless and mobile broadband cards, coin-cell battery, base, DIP switch board, status LED board, and system board.
It also describes the system board layout, recommended tools, post-service checks, and BIOS setup tasks including entering the service tag and clearing CMOS settings or a forgotten password. This manual is written in Chinese.
The manual lists a Torx screwdriver, flathead screwdriver, plastic scribe, hex screwdriver, 8 mm open-end wrench, and pliers.
Open or restart the computer, then press F2 when the F2 prompt appears after the Dell logo during POST.
Remove the top cover, move the password reset jumper from pins 2 and 3 to pins 1 and 2 for about five seconds, then return it to pins 2 and 3 and replace the top cover.
Enter the service tag in the BIOS setup program.