Protein At Beads 4FF is an affinity chromatography medium for the separation and purification of monoclonal antibodies, polyclonal antibodies or Fc-fusion proteins.
Protein At Beads 4FF is an affinity chromatography medium designed for separation and purification of monoclonal antibodies, polyclonal antibodies, or Fc-fusion proteins. The ligand is an alkali-tolerant Protein A variant (Protein At) immobilized on highly cross-linked 4% agarose beads with an average particle size of ~90 µm. The medium offers a binding capacity greater than 40 mg human IgG per mL, operates at pH 3–12, and can be cleaned in place with 0.1–0.5 M NaOH.
The manual details buffer preparation, sample preparation, and a step-by-step purification workflow including column equilibration, sample loading, washing, elution, and column storage. It also covers SDS-PAGE analysis, residual ligand removal, media cleaning procedures, and a troubleshooting table addressing high backpressure, unstable chromatograms, missing target protein in elution fractions, and declining recovery. This manual is written in Chinese.
| Matrix | Highly cross-linked 4% agarose |
|---|---|
| Average particle size | ~90 µm |
| Ligand | Alkali-tolerant Protein A (Protein At) |
| Binding capacity | >40 mg human IgG/mL medium |
| Chemical stability | Withstands all reagents used in antibody purification |
| Working pH range | 3–12 |
| Online cleaning | 0.1–0.5 M NaOH |
| Linear flow rate | 50–300 cm/h |
| Storage solution | 20% ethanol |
| Catalog numbers | YA2471 (1×1 mL, 1×5 mL, 5×1 mL, 3×1 mL+1×5 mL, 5×5 mL) |
High backpressure can be caused by a clogged frit or clogged resin. Clean or replace the frit, perform CIP cleaning, and filter samples with a 0.22 or 0.45 µm filter or centrifuge before loading.
Bubbles in the sample or buffer can cause an unstable curve. Remove bubbles from the sample or column and degas the sample and buffer.
The antibody concentration in the sample may be too low, or the antibody may be degraded. Consider using a medium with the antigen as ligand, or increase the elution pH appropriately.
Recovery may decline due to excessive sample load or a dirty column with reduced capacity. Reduce the sample load and perform CIP cleaning of the resin.