The SDC1215 is a high precision low power Hall switch, used for magnetic field detection and provides a corresponding digital output. At 1.85V typical power consumption is less than 4uW, so it is very suitable for low power products and can be used in battery powered systems that prioritize power consumption, such as touch screen phones, tablets, and laptops. The product has a precise magnetic switch switching point and is insensitive to process variation and temperature variation. It is available in small SOT-23-3, TO-92 and DFN-4L packages.
The SDC1215 is a low power Hall switch that detects magnetic fields and gives a corresponding digital output. Its typical power consumption at 1.85 V is below 4 uW, which makes it suited to battery-powered products where power use matters, such as touch-screen phones, tablets and notebook computers. The device does not distinguish magnetic polarity, so both N and S poles can be used, and a chopper amplifier design reduces sensitivity to offset and noise caused by process variation, operating temperature and mechanical stress. It is offered in SOT-23-3, TO-92S and DFN-4L packages.
The datasheet covers features and applications, pin descriptions and a functional block diagram, ordering information with lead-free (E1) and halogen-free (G1) variants, absolute maximum ratings, recommended operating conditions, electrical characteristics, magnetic switch points for the A, B, C and D grades, the operating principle (power-on reset, oscillator and timing, hysteresis control, bias circuit, chopper amplifier) with a typical application circuit, and package dimensions for SOT-23-3 and TO-92S. This manual is written in Chinese.
| Operating voltage range | 1.65 V to 5.5 V |
|---|---|
| Output type | CMOS output |
| Power consumption at 1.85 V | Typically below 4 uW |
| Packages | SOT-23-3, TO-92S, DFN-4L |
| Operating temperature range | -40 °C to 125 °C |
| Average supply current | 2 uA typical, 4 uA maximum |
| Output saturation voltage | 0.1 V typical at IOUT = 2 mA |
| ESD (HBM) | 4000 V |
| Magnetic operating point, A grade | ±25 GS typical, ±30 GS maximum |
| Standby time | 75 ms typical |
The SDC1215 operates from 1.65 V to 5.5 V, and the recommended supply range in the datasheet is also given as 1.65 V to 5.5 V.
It is offered in SOT-23-3, TO-92S and DFN-4L packages.
No. The device does not distinguish magnetic polarity, and both the N pole and the S pole can be used.
It provides a CMOS output that changes state according to the detected magnetic field.