This manual describes the installation process of INGECON® SUN LITE.
This is the installation manual (document AAY2000IKH01, Rev. _A, July 2010, 72 pages) for the INGECON SUN LITE inverter from Ingeteam Energy S.A. The safety notice states that it contains instructions for the installation, handling and use of the INGECON SUN 2.5 TL, 3 TL, 3.3 TL, 3.68 TL, 3.8 TL, 4.6 TL, 5 TL and 6 TL models, as well as the INGECON SUN 2.5, 3.3 and 5, and models derived from them.
The manual describes the equipment and its options, CE marking and grid-connection regulations, location requirements (environment, IP grade, ambient temperature, atmospheric conditions, pollution degree, noise, ventilation, anchoring surface, altitude), environmental characteristics and EMC requirements, reception, handling, transport, storage and waste treatment. It then gives safety instructions with the required personal protective equipment, installation (wall fixing, cable entries, DC/AC/communications connectors, grounding and grid connection, photovoltaic field connection, electrical disconnection), commissioning and preventive maintenance. This manual is written in Spanish.
| Models covered | INGECON SUN 2.5 TL, 3 TL, 3.3 TL, 3.68 TL, 3.8 TL, 4.6 TL, 5 TL, 6 TL; INGECON SUN 2.5, 3.3, 5 |
|---|---|
| Residual charge time | The equipment can remain charged up to 5 minutes after removing the photovoltaic field and grid supply |
| Voltage measurement equipment | Category III, 1000 V |
| Communications | RS485 serial line connection |
| Grid-connection standards referenced | VDE0126-1-1 disconnection device, ENEL Distribuzione regulations, G83/1 engineering recommendations, Australian and New Zealand regulations |
Only qualified personnel. The manual states that the detailed operations may only be performed by qualified staff, and that all applicable electrical safety legislation must be complied with.
Yes. The manual warns of electric shock risk even after disconnecting the grid and the photovoltaic field, and the equipment can remain charged for up to 5 minutes.
The standard personal protective equipment is safety glasses against mechanical risk, safety glasses against electrical risk, safety footwear and a helmet.
The five golden rules: disconnect, prevent any possible reconnection, verify the absence of voltage, ground and short-circuit, and protect against nearby live parts with safety signage.