Ingeteam SMART DLM Installation and Configuration Manual

About this manual

The document provides instructions for installing and configuring the Ingeteam SMART DLM system, which manages power distribution for electric vehicle charging points. It covers two main versions: the standard SMART DLM and the SMART DLM PRO, detailing their respective hardware kits and compatibility with specific charging models like INGEREV FUSION and INGEREV RAPID 50.

The guide details the installation of external wattmeters (models EM540, EM24 A65, EM530, EM24 A65+) using either direct or indirect measurement methods. It includes specific wiring diagrams for RS485 communication buses, end-of-line resistor connections, and the integration of the RS485 board into the charging point hardware.

What's inside

• Information on this manual
• Power Management Systems
• SMART DLM Kit Hardware
• Wattmeter Connection
• Direct Measure Wattmeter
• Indirect Measure Wattmeter
• INGEREV Charging Point Installation
• RS485 Wiring
• Configuring the Smart DLM
• Safety and Waste Treatment

Specifications

Frequently asked questions

Which charging points are compatible with the SMART DLM software?

The software is supplied with INGEREV FUSION STREET, INGEREV RAPID 50, and INGEREV RAPID ST.

What is the maximum number of INGEREV charging points that can be interconnected for Dynamic Load Management 2.0?

The system allows a maximum of 30 interconnected units.

What is the current limit for using the standard Smart DLM kit versus the Smart DLM Pro versions?

The standard kit is for up to 65 amps per phase, while the Pro versions are for more than 65 amps per phase.

Which wattmeter models are used for installations with a consumption of more than 65 A per phase?

Indirect measure wattmeters are required for three-phase installations with a consumption of more than 65 A in any phase.