This manual describes the installation and operation of the K series chillers.
This is the installation and operation manual (Issue 11.3) for the K series chillers from Applied Thermal Control Ltd., covering the standard KTR, KTC and KTD models. It opens with an introduction, safety warnings and cautions, warranty registration, unpacking instructions and site requirements, followed by installation guidance covering fluid line requirements, the voltage selection option and the chiller filling procedure with Hexid fluid.
The operation section describes the KTR, KTC and KTD models separately, including the alarms on the KTC and the PID controller and set point adjustment on the KTD. A technician section covers fluid flow and pressure adjustment, maintenance and service requirements and troubleshooting, followed by warranty terms and conditions, specifications for the KTR, KTC and KTD, an EC Declaration of Conformity and an appendix on the water cooled condenser option.
| Cooling capacity (KTD) | 480 Watts at 22C |
|---|---|
| Dimensions (KTD), height x width x depth | 515 x 315 x 315 mm (20 x 12.4 x 12.4 inches) |
| Weight (KTD) | 30 kg (66 lbs) |
| Cooling temperature range (KTD) | 4C - 30C |
| Power requirements (KTD) | 3 Amps 230V 50/60Hz, 7 Amps 115V 60Hz |
| Standard electrical supply versions | 230V 50Hz 3A or 115V 60Hz 6A |
| Required clearance | At least 250 mm (10 inches) front and rear |
| Warranty | 2 years parts, 1 year labour |
Push and release the 'P' button so the display flashes 'SP 1', then press UP or DOWN to change the value. The new value is stored automatically after approximately 10 seconds.
Hexid fluids are the recommended coolant choice. The manual warns against using other anti-freeze mixtures because they can damage the K series pump seals.
Leave a clearance front and rear of the unit of at least 250 mm (10 inches).
The warranty is 2 years parts and 1 year labour.