Jacuzzi LG74000D Pure Air Whirlpool Salon Spa Bathtub Operating Manual

This document is the operating manual of Jacuzzi Luxury Bath's Pure Air® Whirlpool Salon® Spa LG74000D


Jacuzzi LG74000D Pure Air Whirlpool Salon Spa Bathtub Operating Manual - cover page
Brand
Jacuzzi
Category
Other
Document type
User Manual
Language
English
Pages
54
File format
PDF
File size
9.2 MB
Published
30 October, 2023
Updated
30 October, 2023
MD5 checksum
5E38C12D92A013E1511484CF099FF120

About this manual

This operating manual covers the Jacuzzi LG74000D bathtub and its Pure Air, Whirlpool, and heated soak systems. It explains general operation, including filling the tub above the highest jet and turning systems off before exiting, and describes the J2 and J4 control panels.

Reference illustrations and schematic diagrams show the Pure Air, Whirlpool, and heated soak layouts. The manual also covers Auto-Dri air-channel drying, RapidHeat, chromotherapy controls, cleaning, maintenance, and troubleshooting; Spanish and French installation instructions are directed to Jacuzzi's website.

What's inside

  • General Operation Information
  • Pure Air® Operations
  • Pure Air® Auto-Dri™ Air Channels
  • Whirlpool Operations
  • Heated Soak
  • RapidHeat™
  • Cleaning
  • Maintenance
  • Salon® Spa Operations
  • Troubleshooting Procedures

Specifications

Water fill levelAt least 1 in to 2 in (25 mm to 51 mm) above the highest jet or air inlet
Pure Air blower electrical requirement120 VAC, 15 A dedicated GFCI circuit
Whirlpool pump/motor electrical requirement120 VAC, 20 A dedicated GFCI circuit
Blower shutoff time20 minutes

Frequently asked questions

How high should the water be above the highest jet or air inlet?

Fill the bathtub until the water is at least 1 inch to 2 inches (25 mm to 51 mm) above the highest jet or air inlet.

What happens after the blower shuts off?

Twenty minutes after the blower has shut off, it turns on for a one-minute drying cycle to blow out any remaining water.

How do I start the drying cycle if I used the bath without the blower?

Turn the switch ON and OFF again as you exit the bath; the drying cycle will occur in 20 minutes.

What is the default daily Auto-Dri cycle setting?

The default is no pre-set daily Auto-Dri cycle, so it must be set upon installation; after a power failure the system defaults to no daily Auto-Dri cycle.

Download PDF (9.2 MB)

More Jacuzzi Manuals


View all Jacuzzi manuals →