Geokon GK-4675 Static Level Installation and Operation Manual, mainly introduces the introduction, installation, reading, temperature change correction, troubleshooting and other content of the static level system.
The Geokon GK-4675 is a high-precision liquid level system designed to measure relative settlement at multiple points. A series of sensor containers are joined by liquid lines, and the level in each container is measured by a precision vibrating-wire sensor fitted with a free float; vertical displacement at every point is referenced to one datum container whose movement is known or determined by other means.
The manual covers installation (mounting the reservoirs, connecting the liquid lines, filling the system, installing the sensors and connecting the vent tubes), taking readings with a GK-403 or BGK-408 readout on the "B" range, the settlement calculation formula with a worked four-point example, temperature correction of the vibrating-wire readings, and troubleshooting of coil resistance and cable faults. This manual is written in Chinese.
| Coil resistance | 180 ±10 Ω plus cable resistance |
|---|---|
| Cable resistance (standard 22 gauge copper wire) | about 15 Ω per 300 m |
| Fill level at which filling is stopped | about 10 cm below the reservoir opening |
| Readout instrument | GK-403 or BGK-408, "B" range |
| Mounting bolt diameter | 10 mm expansion bolts |
| Temperature correction coefficient | 0.0002 per °C of water temperature |
Readings are taken with a GK-403 (or BGK-408) readout, with the instrument set to the "B" range.
The coil resistance should normally be 180 ±10 Ω plus the cable resistance.
Pure water is used to fill the system; if the ambient temperature may drop below zero, a proportion of antifreeze is added to the water.
ΔELx = (R1x − R0x)Gx − (R0Ref − R1Ref)GRef, where each sensor's coefficient G is taken from its calibration sheet.