The GK-4450 displacement sensor is the main component of the Geokon A series multiple displacement meter. It is composed of a vibrating string detector that has been strictly heat treated and a stress-free spring that is connected to one end of the vibrating string and the other end of the sliding rod.
The Geokon GK-4450 is a vibrating wire displacement sensor used mainly in Geokon A-series multi-point extensometers. It uses a tensioned vibrating wire and spring; as the sliding rod moves, the wire tension and vibration frequency change, and a vibrating wire readout can measure the displacement. The sensor is sealed and can operate at 250 Psi (about 1.7 MPa).
The manual covers preliminary testing, installation, cable connection, electrical interference, initial readings and lightning protection. It also explains reading with the GK-401 and GK-403 readouts, temperature measurement, displacement calculation, temperature correction, troubleshooting, and technical characteristics in the appendix. This manual is written in Chinese.
| Operating pressure | 250 Psi (about 1.7 MPa) |
|---|---|
| Coil resistance | Approximately 180 ± 10 Ω |
| Cable resistance | Approximately 48.5 Ω/km for GK2-250V6 cable |
| Insulation resistance | More than 20 MΩ between conductor and shield |
| Model variants | 4450-12 mm, 4450-25 mm, 4450-50 mm, 4450-100 mm, 4450-150, 4450-200, 4450-300 |
It is mainly used in Geokon A-series multi-point extensometers and measures displacement from changes in vibrating wire frequency.
Set the display selector to the “B” position, connect the black and red clips to the vibrating wire signal and the blue lead to the cable shield, then read the displayed digits.
After the nylon clip is removed, the sliding rod retracts and the reading should be between 2000 and 3000 digits.