Parker SSD Drives provides DC Controller product user manual
The Parker SSD Drives 514C is a DC motor controller intended for industrial motor speed control. It controls DC shunt-wound or permanent magnet motors in all four quadrants, operating from a single-phase 110–415 Vac, 50/60 Hz supply with an auxiliary supply. Speed control uses a closed loop with switch-selectable tachogenerator or armature voltage feedback, and a current loop.
The manual covers product overview, technical specification, pre-installation planning, terminal descriptions and wiring, installation, setting-up and commissioning, option switches and potentiometers, diagnostics and fault finding, and service and repair. The 514C range includes 4 A, 8 A, 16 A, and 32 A full-load current ratings. It includes stall detection and an instantaneous overcurrent trip.
| 514C/04 full load current | 4 A DC |
|---|---|
| 514C/08 full load current | 8 A DC |
| 514C/16 full load current | 16 A DC |
| 514C/32 full load current | 32 A DC |
| AC supply | Single-phase 110–415 Vac, 50/60 Hz |
| Motor type | DC shunt-wound or permanent magnet motor |
| Quadrant operation | All 4 quadrants |
| Feedback source | Tachogenerator or armature voltage, switch selectable |
| Stall detection | Removes motor current after approximately 60 seconds |
| Overcurrent protection | Instantaneous overcurrent trip |
It is designed to control the speed of a DC shunt-wound or permanent magnet motor.
It operates from a single-phase AC mains supply of 110 Vac to 415 Vac at 50 or 60 Hz.
A Stall detection circuit protects the motor by removing current from it.
All incoming supplies must be isolated before working on the equipment.