The document is about Jumbo Stencil Cutting Machine operating manual.
This operating manual and parts list for the Diagraph Jumbo Stencil Cutting Machine explains preparation before use, loading a stencil board between the feed wheels, aligning it with the red lines, selecting characters on the die disc, and cutting by pulling the handle. It also describes using the spacing character and cutting successive lines.
The document includes troubleshooting for characters that do not cut, improper spacing and stencil boards that do not feed straight, plus maintenance and punch and die replacement instructions. A parts list with stock numbers and a punch and die assembly number list are included.
| Machine size | 2 in. |
|---|
Pull the handle approximately halfway down until a definite clicking sound is heard.
Adjust the stop screw nearest the operator on the yoke to lengthen the handle stroke, inspect the punch and die for paper segments, and contact the Diagraph sales office if the problem continues.
No. The manual says not to attempt to cut metal because it will permanently damage the machine.
The manual says punch and die replacement should be performed by qualified Diagraph personnel.