This document introduces the features and functions of TORO 1/10 ESC, including acceleration, braking control function, red copper connector, intelligent thermal management kernel algorithm, laminated copper stack control technology and cooling fan design.
This manual guides users through installing, calibrating, and operating the SKYRC 1/10 ESC. It covers safety precautions, wiring, throttle/brake settings, and thermal management. Calibration is required for new transmitters or after changes. The ESC supports both sensor and sensorless brushless motors and can be programmed via PC, smartphone, or SKYLINK.
The ESC features turbo and boost timing adjustment, 10 user profiles, and safety protections including low voltage, overheat, and signal loss. It uses red copper connectors and laminated copper stack technology for reduced resistance and heat. Cooling is aided by an 8V 20000RPM fan and aluminum heat sinks. The ESC must be mounted in a ventilated area and never run without load at full throttle.
| Battery Support | 4-9 cells NiMH or 2-3 cells LiPo |
|---|---|
| Throttle/Brake Precision | 1.0 |
| Cooling Fan | 8V 0.2A 20000RPM |
| User Profiles | 10 sets |
| Programming Methods | Program box (SK-300046), PC via SKYLINK (SK-600013), or smartphone via Bluetooth (SK-600058) |
Turn off the ESC, connect it to battery and motor, turn on transmitter, press and hold ESC switch for few seconds. Then set neutral, full throttle, and full brake positions by pressing switch while holding trigger in each position.
Red LED blinking = zero timing; Red LED on = motor boost and turbo timing on; Green LED blinking = calibration in progress; Green LED on = ESC ready.