This manual is the operation manual of Kemppi MR 200 and MR 300, which mainly introduces the connection, installation, operation and setup of the device.
This manual explains how to operate and set up Kemppi MR 200 and MR 300 panels for MIG and MMA welding. It covers mounting, parameter adjustments, and safety precautions. The panels are designed for use with FastMig M 320, 420, or 520 power sources. Detailed setup parameters for MIG and MMA processes are provided, including gas settings, wire feed speed, and voltage controls.
The manual also includes error code information and disposal instructions. Safety warnings and important notes are highlighted to prevent damage or injury. Users are advised to read the manual before first use and to consult Kemppi’s website or authorized dealers for support.
| Wire Feed Unit Compatibility | MXF 63 for MR 200, MXF 65 and 67 for MR 300 |
|---|---|
| Power Source Compatibility | FastMig M 320, 420 or 520 |
| Factory Setting for MIG Dynamics | 0 |
| Default Device Address | 3 |
The panels are designed for use with FastMig M 320, 420, or 520 power sources.
Place the bottom edge of the panel behind the securing clips, remove the fixing pin from the top edge, push the panel gently into place, and secure it with the provided clip (for MXF 65 only).
The factory setting is 0, which is recommended for general use to adjust the roughness of the arc.
Press buttons 3 and 5 simultaneously for more than 1 second. 'Gas' indicates air-cooled, 'CooLEr' indicates liquid-cooled.