Spider 6 Pilot Manual introduces the use of Spider 6, including installation, power on, GPS signal, Iridium connection, etc.
This manual provides instructions for installing and powering the Spider 6 aircraft tracking device. It details the requirements for positioning the unit to ensure optimal GPS and Iridium satellite connectivity, including warnings regarding electrically heated windshields.
| Power Supply Range | 10VDC to 28 VDC |
|---|---|
| Power Supply Current | 1.5 A peak current |
| Recommended Fuse | 3A in-line fuse |
| GPS Lock Time | within 1 minute |
| Startup to Connection Time | less than 2 minutes |
| Watch-off Message Time | up to 60 seconds |
| Iridium Transmission Delay Limit | 120 seconds |
| Queue Storage Capacity | maximum of 10 points |
The Spider should be mounted up on top of the instrument panel as far forward under the glare shield as possible to maximize sky visibility and be free from obstructions.
A GPS lock should be acquired within 1 minute in the general case.
Press and hold the Mark button to cycle through brightness levels, then release when the desired level is reached.
It means the Spider is stuck in programming mode and a firmware restoration is required.