This manual provides information on how to use the Ford Code Reader (FCR) and how to use the FCR for vehicle diagnostics.
The Ford Digital Code Reader is a diagnostic tool designed to retrieve engine and transmission fault codes from the vehicle's computer system. It is intended for use by both experienced technicians and consumers with little experience in automotive diagnostics.
This manual covers safety precautions, an introduction to Ford's electronic control systems (EEC), and detailed procedures for connecting the device to test connectors. It includes specific instructions for retrieving Key On Engine Off (KOEO) and Key On Engine Running (KOER) codes for EEC-IV and MCU systems, along with definitions for fault codes applicable to cars and trucks manufactured between 1981 and 1995.
| Vehicles Covered Years | 1981 to 1995 |
|---|---|
| Compatible Brands | Ford, Lincoln, Mercury |
You must always turn the ignition off before connecting or disconnecting any test equipment to prevent sparks that could damage the equipment or the vehicle's electronics.
The test connector is usually found under the hood of the vehicle.
You must use a digital multimeter with at least 10 Megohms of impedance to prevent damage to the on-board computer.