This manual begins with important safety safeguards, warning about electric shock, proper ventilation, and correct power‑cord handling. It also outlines service recommendations and advises when to contact qualified service personnel.
The installation section explains how to connect the BBE 1002 in a tape‑monitor loop, pre‑amp loop, or as a single‑source processor, and describes additional wiring for tape decks and other processors. Operational details cover the front‑panel controls, LED indicators, and the three frequency‑band processing paths, while the tape‑dubbing and compatibility chapters explain how the unit works with other audio equipment.
| Input connectors | RCA rear‑panel connectors |
|---|---|
| Channel indicator LEDs | Red to green per channel |
| Low‑frequency group delay | ~2.5 ms |
| Mid‑range group delay | ~0.5 ms |
| Low‑frequency control | Flat, cut or boost at 50 Hz |
Yes. The manual states the BBE 1002 is designed to interface easily and may be installed in a tape‑monitor loop.
The low‑frequency group is delayed by about 2.5 ms.