The Lenovo QDI A10B motherboard guide provides step‑by‑step instructions for installing the chipset, audio, and other drivers from the supplied CD. It also covers BIOS setup, including standard CMOS parameters, advanced features, and power‑management options such as ACPI suspend‑to‑RAM.
Additional sections describe the function of each motherboard jumper, connector pinout diagrams (hard‑disk LED, power LED, speaker, reset switch), and procedures for clearing CMOS or setting supervisor passwords. This manual is written in Chinese.
| Audio Codec | AC97 standard sound card |
|---|---|
| Hard Disk LED Connector Pin 1 | LED ANODE |
| Power LED Connector Pin 1 | LED ANODE |
| BIOS Write‑Protection | Enabled via BIOS jumper |
Insert the supplied driver CD, run the LX_Chip folder’s Setup.exe, select the appropriate driver (e.g., VIA ATAPI Vendor Support), enable DMA mode if needed, and finish the installation before rebooting.
Power off the computer, unplug the case power cable, and use the CMOS clear jumper (JCC) set to the clear position before powering the system back on.