This manual provides an overview of the QDI P6I810/WII-A motherboard, including its supported CPUs, chipset, memory modules, and expansion slots. It also explains the layout of connectors and pins for power, reset, LEDs, speaker, and USB ports.
Detailed instructions cover BIOS configuration, CMOS reset procedures, Wake‑On‑LAN jumper settings, and step‑by‑step driver installation for the Intel 810 chipset, graphics, and audio devices. This manual is written in Chinese.
| Supported CPU bus speeds | Up to 466 MHz for Intel Celeron processors |
|---|---|
| Chipset | Intel 810 |
| Memory slots | Two 168‑pin 3.3 V DIMM slots, 32‑512 MB SDRAM |
| IDE devices | Four IDE devices (hard disk and CD‑ROM) |
| Expansion slots | 1 AMR slot, 3 PCI slots, 1 ISA slot |
| USB ports | 2 USB ports |
| Power management features | ACPI and Wake‑On‑LAN support |
Press the key within a few seconds after power‑on to open the BIOS setup menu.
Clear the CMOS by short‑ing the 1‑2 pins on the CMOS reset jumper, then power on the system.
Insert the Lenovo driver CD, navigate to D:\NLX_ChipN8l0infNInf (or similar), and run SETUP.EXE.
Select “Load Optimized Defaults” in the BIOS menu, confirm with Y, then save and exit.