This manual introduces the operation, installation and maintenance of the ARO® squeezing system
This manual covers the complete setup of the NPCXXR-XX-XXX pneumatic material handling system, including unpacking, installation of the lift cylinder, hose routing, and initial air pressure adjustment. Detailed safety warnings and step‑by‑step procedures guide operators through lifting, lowering, and normal operation of the system.
A parts list and service part numbers are included for routine maintenance and repair of heavy‑duty components such as regulators, filters, and lift cylinders. The document also specifies required air pressures, travel limits, and recommended lubrication for the moving plate. This manual is written in Chinese.
| Maximum air source pressure | 150 psi |
|---|---|
| Operating air pressure | 20 psi (1.4 bar) |
| Moving plate air pressure | ≈8 psi (0.55 bar) |
| Starter motor model | C-12 |
Connect the air source (up to 150 psi) to the inlet and adjust the regulator to about 20 psi (1.4 bar) before starting the system.
Keep hands away from the moving plate, as it can descend quickly and cause injury; follow the warning on page 2 of the lift cylinder manual.
Apply a compatible grease to the moving plate to ensure smooth contact with the bucket and prevent material from sticking to the seals.
Part number 29960 is used for repairing the 27354‑000 heavy‑duty regulator.