V100 Door/Reader Interface is a complete, full-featured hardware/firmware infrastructure for access control software host systems. The V100 Door/Reader Interface connects two door access card readers through Wiegand or Clock-and-Data interfaces to control one or two doors. Features of the V100 include on-board flash memory to allow over-the-network program updates. The V100 connects via a high-speed RS-485 network to the V1000. The V1000 communicates with the system host over 10/100 Mbps Ethernet or the Internet using an industrial standard TCP/IP protocol. This architecture significantly reduces impact on an enterprise LAN because only one TCP/IP address is used for every 32 interfaces and the lowest level transaction processing is done on the RS-485 network.
This manual describes the VertX V100 access controller, a full‑function hardware/firmware platform for door security systems. It explains the V100's two door/reader interfaces, RS‑485 networking to V1000, and the TCPVIP protocol used for communication with the host system.
Installation guidelines cover mounting the unit in a NEMA‑4 enclosure, power requirements, cable selections, and environmental limits. The document also lists certifications, warranty information, and part numbers for service and replacement. This manual is written in Chinese.
| Dimensions (W x H) | 147.32 mm × 122.55 mm |
|---|---|
| Enclosure material | UL94 polycarbonate |
| Power consumption (no readers) | 60 mA @ 9‑18 VDC |
| Maximum reader power output | 500 mA |
| Relative humidity | 5 % – 95 % non‑condensing |
| RS‑485 cable distance | 1220 m (4000 ft) |
| Wiegand cable distance | 150 m (500 ft) |
| Certifications | UL 294, UL 1076 |
The RS‑485 connection can reach up to 1220 m (4000 ft) when using Belden 3105A cable.
The V100 provides two Wiegand (Clock‑and‑Data) ports for two readers.
It is certified to UL 294 and UL 1076, and meets other regional marks such as CE and C‑Tick.