Victron Energy MPPT 150/70 CAN-bus Error Er 67: BMS connection lost

MPPT 150/70 CAN-bus · taken from the manufacturer’s manual, pages cited

Error codeEr 67

The BMS connection has been lost. The manual's first action is: “Connection to the BMS lost, check the CAN bus cabling. When the charger needs to operate in stand-alone mode again, change to setup menu setting 'BMS' from 'Y' to 'N' (setup item 31).”

Model
Victron Energy MPPT 150/70 CAN-bus
Display shows
BMS connection lost (Er 67)
Type
Error code
Source
Manual p. 19

What Er 67 means

BMS connection lost p. 19

What to do

  1. Connection to the BMS lost, check the CAN bus cabling. When the charger needs to operate in stand-alone mode again, change to setup menu setting 'BMS' from 'Y' to 'N' (setup item 31). p. 19

If Er 67 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Victron Energy service.

Open the manual at page 19 All MPPT 150/70 CAN-bus error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er 67; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Victron Energy. Found a mistake? Report an error.