Fault code63
Emergency stop is triggered by an emergency stop command received from digital input or fieldbus, and a new run command can be accepted after reset. The manual's first action is: “New run command is accepted after reset.”
- Model
- Vacon NXS/P
- Display shows
- Emergency stop (63)
- Type
- Fault code
- Source
- Manual p. 156
What 63 means
Emergency stop p. 156
Common causes
- Command for emergency stop received from digital input or fieldbus. p. 156
What to do
- New run command is accepted after reset. p. 156
Before you service the product, read the safety instructions in the manual p. 13.
If 63 is still not resolved
- Contact service or dealer for assistance. p. 13 “WARNING! Before you do electrical work, make sure that there is no voltage in the components of the drive.”
- Contact service or dealer for assistance. p. 14 “CAUTION! Do not touch the components on the circuit boards. Static voltage can cause damage to these components.”
This page summarises what the manufacturer’s manual says about 63; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Vacon. Found a mistake? Report an error.