Thermo Fisher Scientific DT80 Error E114: Command parameter error

DT80 data logger · taken from the manufacturer’s manual, pages cited

Error codeE114

The DT80 received an invalid parameter for a command it was given. The manual lists no action for this code.

Model
Thermo Fisher Scientific DT80
Display shows
Command parameter error (E114)
Type
Error code
Source
Manual p. 404

What E114 means

Command parameter error p. 404

Common causes

  • Invalid parameter specified for a command p. 404

If E114 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Thermo Fisher Scientific service.

Open the manual at page 404 All DT80 error codes Manual details & download

This page summarises what the manufacturer’s manual says about E114; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Thermo Fisher Scientific. Found a mistake? Report an error.