Silicon Laboratories Si1145/46/47-M01 Error 0x80: Invalid Command Encountered during command processing

UV sensor · taken from the manufacturer’s manual, pages cited

Error code0x80

An invalid command was encountered during processing. The manual lists no action for this code.

Model
Silicon Laboratories Si1145/46/47-M01
Display shows
Invalid Command Encountered during command processing (0x80)
Type
Error code
Source
Manual p. 41

What 0x80 means

Invalid Command Encountered during command processing p. 41

Common causes

  • Invalid Command Encountered during command processing p. 41

If 0x80 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Silicon Laboratories service.

Open the manual at page 41 All Si1145/46/47-M01 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 0x80; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Silicon Laboratories. Found a mistake? Report an error.