Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The password is incorrect. The manual's first action is: “Check the current password, and re-enter it.”
The user name already exists, the user can not be registered. The manual's first action is: “Check the user name, and register with a different name.”
The device cannot establish a connection to the server. The manual lists no action for this code.
The system has reached its maximum number of connected clients, preventing new logins. The manual's first action is: “Wait for the other client to log out.”
Login failed because user name or password is incorrect. The manual's first action is: “Check the user name and password that you have entered.”
The system cannot establish a connection to the server. The manual's first action is: “If you cannot connect to the server, stop the server firewall, or register DFMServer.exe and DLGServer.exe as exceptions in the se…
All 73 error codes of the Yokogawa GA10/GA10CL/GA10UP Yokogawa GA10/GA10CL/GA10UP with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The battery has been operating for more than one hour. The manual's first action is: “Replace battery pack”
G-Switch loop between pins 5 and 12 is not present The manual's first action is: “Verify D-Sub connector jumper is installed by checking for less than 1Ω between pins 5 and 12. Repair as necessary. NOTE: When the inst…
The system is not receiving position data via long message protocol. The manual's first action is: “Turn on navigation system”
The ELT is reporting low output power due to a bad load or faulty unit. The manual's first action is: “1) Terminate antenna cable at antenna connection end w/50Ω load. Repeat self-test. If error clears, proceed to ste…
Code 3 is not used in the ELT 1000. The manual lists no action for this code.
Code 2 is not used in this model. The manual lists no action for this code.
The system is operating normally. The manual's first action is: “One pulse two seconds long of the local LED, remote light, and buzzer. This pulse is suppressed if problems are found during self-test.”
All 7 error codes of the ARTEX ELT 1000 Emergency Locator Transmitter with their meaning, causes and what to do, taken from the manufacturer's manual with page references.