Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
CAN'T OPEN INPUT FILE WITH THE TEMPLATE DESCRIPTION because the template description exists in current configuration. The manual's first action is: “Make sure that the template description contained in the input geome…
AN EFFICIENCY CALIBRATION CALCULATION (ECC) PROCESS IS ALREADY RUNNING. The manual's first action is: “WAIT FOR ITS TERMINATION BEFORE LAUNCHING ANOTHER ECC PROCESS.”
Warning that not all tests were performed. The manual lists no action for this code.
Bad date range specified. The manual lists no action for this code.
Warning that the bias test was not performed because one or more values had error = 0. The manual lists no action for this code.
Nuclide or Nuclide line not found. The manual lists no action for this code.
No records to transfer. The manual lists no action for this code.
The record being transferred has the same time-stamp as one that's already on file - but there's no over-write flag. The manual lists no action for this code.
Memory allocation error. The manual lists no action for this code.
General communication failure. The manual lists no action for this code.
Invalid intermediate file; delete *.ITF files from the subdirectory and try again. The manual's first action is: “Delete the *.ITF files from that subdirectory and try again.”
Error during CAM file access. The manual lists no action for this code.
Error communicating with VDM. The manual lists no action for this code.
Temp. file creation error. The manual lists no action for this code.
Windows sockets initialization failed or there isn't enough room for Absorber(s), or material selection is missing for the container. The manual lists no action for this code.