Moeller M1-800-MOELLER Error Ptc: A high temperature has been measured by the Zem-I/O-NET.

Electronic overload relay · taken from the manufacturer’s manual, pages cited

Fault codePtc

A high temperature has been detected by the Zem-I/O-NET system. The manual's first action is: “Check the motor for problems and the PTC connections on the ZEM-I/O-NET.”

Model
Moeller M1-800-MOELLER
Display shows
A high temperature has been measured by the Zem-I/O-NET. (Ptc)
Type
Fault code
Source
Manual p. 8

What Ptc means

A high temperature has been measured by the Zem-I/O-NET. p. 9

Common causes

  • A high temperature has been detected by the ZEM-I/O-NET. p. 9

What to do

  1. Check the motor for problems and the PTC connections on the ZEM-I/O-NET. p. 9

If Ptc is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Moeller service.

Open the manual at page 8 All M1-800-MOELLER error codes Manual details & download

This page summarises what the manufacturer’s manual says about Ptc; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Moeller. Found a mistake? Report an error.