Maytag 8TMHW6630HW Error E01

Model

Maytag 8TMHW6630HW

Display shows

E01

Type

Error code

Source

Manual p. 43

• Meaning
• Common causes
• What to do
• Still not solved
• Source

What E01 means

Check for proper water supply. p. 43

Common causes

• Check for proper water supply. p. 43
• Both hoses must be attached and have water flowing to the inlet valve. p. 43
• Both hot and cold water faucets must be ON. p. 43
• Inlet valve screens on washer may be clogged. p. 43
• If used, auto shut-off connectors and hoses must be properly installed and in working order. p. 43
• Check for proper inlet hoses. p. 43
• Check plumbing for correct drain hose installation. Drain hose extends into standpipe farther than 4½" (114 mm). p. 43
• Make sure the drain hose is not kinked, pinched, or blocked. p. 43
• Use drain hose form and securely attach to drainpipe or tub. p. 43
• Not using HE detergent or using too much HE detergent. p. 43

What to do

1. Unit will drain for 8 minutes while door remains locked. The drain cycle must be allowed to complete or the error code cannot reset. When complete, touch POWER once to clear the code. Then touch POWER again to restart washer. p. 43
2. Remove any kinks in the inlet hose. p. 43
3. Use only manufacturer's recommended inlet hoses. p. 43
4. Check drain hose for proper installation. p. 43
5. Remove any clogs from drain hose. p. 43
6. Lower drain hose if the end is higher than 96" (2.4 m) above the floor. p. 43
7. Use only HE detergent. Always measure detergent and follow manufacturer's directions based on load size and soil level. p. 43

If E01 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Maytag service.

This page summarises what the manufacturer’s manual says about E01; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Maytag. Found a mistake? Report an error.