The system has completed its operating cycle and entered Stand-By mode. The manual's first action is: “Household voltage is too high or too low (± 20%). Check the voltage is within the range stated on the device housing.”
- Model
- Intex ECO5110 & 6110
- Display shows
- Stand-By Mode (Operating Process finished) (93)
- Type
- Alarm code
- Source
- Manual p. 19
What 93 means
Stand-By Mode (Operating Process finished) p. 25
After a heavy rain or if the pool is dirty, press the "BOOST" button to shock the pool again. p. 18
The system will automatically turn itself back on in 24 hours, starting its daily cycle of chlorine production. p. 18
Common causes
- 1. LED display is off and the "SERVICE" light is on - the system does not power up. p. 25
- 2. Caused by high humidity. p. 25
- 3. PCB failure. p. 25
Safety warnings — read before you start
- WARNINGWARNING. Do not bury the electrical cord. Locate the cord where it will not be damaged by lawn mowers, hedg p. 3
What to do
- Household voltage is too high or too low (± 20%). Check the voltage is within the range stated on the device housing. p. 25
- Run the system during midday and avoid running it during dawn, foggy or raining time. Place a piece of tile or similar pad, 15"×15" (38×38 cm) in size, between the device and the ground to keep ground water evaporation away from the system. p. 25
- Contact Intex Service Center. p. 25
If 93 is still not resolved
- Contact Intex Service Center. p. 25 “Contact Intex Service Center.”
This page summarises what the manufacturer’s manual says about 93; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Intex. Found a mistake? Report an error.